Recent content by 270win

  1. 2

    Clunky shifting, missed shifts

    My 08 goes into 1st sounding like a house brick being thrown on a tin roof, it don't worry me at all. Now, let's not mention 1st also sounds like a 1972 Corolla in reverse...
  2. 2

    Exhaust studs. Exracting them

    Be real careful with the screw extractor. If you snap one of those in there you could have a load more grief / cost getting it out. I presume that's what you mean by stud extractor, an Ezyout?
  3. 2

    I don't think this is normal

    I’d guess master cylinder seal. Looking at the diagram attached, if the primary seal (Green circle) is ok it won’t leak fluid out the unit, but if the piston seal (Red circle) is worn or split the fluid will bypass this seal and the lever will sink or bite point as you put it will move...
  4. 2

    Anyone done these mods ?

    Well said Ivan, there's only one flash I was comfortable to go with.
  5. 2

    would you use this jack on you bike ?

    I have one very similar, works a treat with my WR450 dirt bike. Useless for the FZ1 thought.
  6. 2

    Naked and clean.

    Cheers ballmead. No I dont mate, however the bloke I bought it from about a year ago worked in the city I think, so you may well have seen it.
  7. 2

    Naked and clean.

    The old FZ hadn't had a good wash for a while.
  8. 2

    FZ1 Parts - Ivanized Ecu, PCV, etc

    Interested in the R1 shock and V3 adaptor, based on your response to Dicko, am I out of the running due to being outside the US? I'm in 5094 South Australia. Cheers!
  9. 2

    FZ1 on the Drag Strip

    Always knew the models before the "Gentelmen's Agreement" had formidable top speed, didn't know they were capable of single digit quarters too.
  10. 2

    FZ1 on the Drag Strip

    Not bad times then from a stock Busa that’s 15 years old. I wouldn’t have thought they would be that quick.
  11. 2

    FZ1 on the Drag Strip

    Is the old mans Hayabusa modified too?
  12. 2

    Testrun Fz1 Turbo with 315 horspower

    Wow! That is tuff as fuk.
  13. 2

    Latest mods almost complete and I’m getting a little exited….

    Latest mods almost complete and I’m getting a little excited…. My full Yoshi system with R77 carbon fibre has arrived and the headers are bolted on, a set of block off plates and my ECU are in transit form the USA having been flashed by Ivan, the front and rear foot peg frames are at the powder...
  14. 2

    anybody familiar with a yz 426?

    Mate I would still think carbi, start simple check float level. Here is a link to a workshop manual scan, it's for an 01 but is the same as 00 I think. http://motoman393.thumpertalk.com/tech/files/426_manual.html Another link to a similar sounding prob, note that there is a slide in the...
  15. 2

    Australia NSW insurance advice needed.

    Mate $1200 for full comp is BS. I just did a quick online quote with Famous Insurance and full comp is $391 or $308 if you’re over 40, both at $500 excess for market value. This is not including gear but that can be added. Their market value is around $10k for an 08, i know this for a fact as...
Back
Top