Yep sounds about right, You got an N or an S model? The length just gets the controller box under the tank (just) on an N not too fussed on an S as you can hide it in the fairing. Also I ended up using some opaque plastic off a cheap Coles (Supermarket) document folder between the unit and the...
I emailed them, Norbert?
Sounds about right from memory. Make sure you get plenty of cable between the controller and the display. Are you talking to Norbert at Healtech?
Cables can stay in place. Just remove the 10mm nut off the flat sided shaft. use the flats to key in your actuator. You got a 3D printer? That would be fun
Min speed for steady cruise is about 90kph 53mph? Below that its unreliable. Get the stroke as long as possible. Mine was only restricted by the throttle body bracing. PPM was advised by Norbert at Heal Tech that do Speedo Healers he also advised cruise to be wired in before the Speedo Healer.
I put mine in upside down in the exup spot. perfect fit. The slack I set where the cable exits the Rostra unit, slacken the torx screws on the cable "boss" and measure the gap there with a finger on the throttles to check for movement. I connected mine to a crank off the side of the throttle...
All but 7,8 & 9 Mine set to V8 low to take some sensitivity off, I figure a V8 will require a lot less throttle movement/speed than say a 1.6l car to keep speed constant so I have 7 8 & 9 set off