motor

  1. stretched06

    New ride

    https://photos.app.goo.gl/SCxjhqyXTKU1LfZI3 Back at it! Well should be by the end of the month. Taking it apart and checking everything before I make a pass. 2008 zx14, built motor with nos.
  2. K-FZ1-02

    Run without exup?

    The answer may be on the site somewhere but I have yet to find it. I am new with a used 2002 FZS10 with 34,000 miles. Besides having to address some clutch issues etc. My motor began to run really ratty. It appears the servo motor for the exup valve is not working as when I wired the valve open...
  3. Chameleon

    Infamous 07' fz1 frame crack!

    So I was out on a ride yesterday and during a pit stop was looking over my bike and noticed there's a hairline crack on a weld in my frame just above the motor on the right side. I've only put about a thousand miles on the bike (about 17k on odo) and hadn't seen it before. I've seen other...
  4. Rx_FZ1

    Buy a new motor or rebuild this one?

    After hours of troubleshooting, disassembling and reassembling the clutch I have come to the conclusion my transmission is shot at 28,000 miles. Gear box is shot, no 4th or 5th gear. Dies in first, will take off in second but with terribly high revs, 3rd is intermittent and cuts out. Only gear...
  5. B

    2014 FZ1 for Sale

    Crashed 2014 FZ1 for Sale I'm selling a crashed 2014 FZ1. The bikes has 600 miles on it and as you can see from the pictures, the front end needs to be replaced. The tank is dented but does not leak, no damage to the motor or side cases and the bikes runs and starts up just fine. The bike is...
  6. N

    Stock exhaust and the EXUP valve

    Hi I was wondering if anyone can help me. I have to install my stock exhaust back on and after hooking everything up I don't think the servo motor cables are doing what they are supposed to do. If I turn my key on, the servo motor turns to the right a little bit, but the actual EXUP valve does...
  7. B

    2008 fz1 knocking sound at 4k-5k motor has 10k in it

    Hello all I just replaced my 2002 fz1 and I rode it for 80k. so I sold it and got a 2008 with 9400 miles. right after I got it I heard knocking at 4000 to 4800. I have been going nuts trying to find it. I think its rod knock after noticing the sound now I can hear it at 2k to 3k but very quite...
  8. N

    Need Gen I Engine complete Australia

    After putting a conrod through the side of my motor I need a new motor for an otherwise perfect ride (or should I say "push"). If anyone in Australia is wrecking a Gen I with a good motor I would love to hear from you. Thanks. Dennis
Back
Top