Recent content by Stamos

Do you clean your bike using a pressure washer? If so maybe that is responsible for the rust, i am familiar with this problem...

Which risers have you tried? I think i'm not going to change them finally, i like the looks of the stock ones (compared to the sv650 riser mod) plus i'm sceptical about the quality of the ebay risers i posted above. I've already installed black barend mirrors and levers purchased from ebay and...

The same frame-forks colour combo have the silver 06 FZ1n"s sold here too...

When was the last time you changed them?

Thanks for your suggestion but the plan is to go about an inch lower than stock! If anyone has some experience in this subject please share your thoughts!

I know this subject has been discussed a million times but today as i was searching for alternatives to the sv650 riser mod i found this... What do you think?

Does it backfire when you reapply throttle? If so i think this is normal... If it backfires with the throttle closed i think it is a little bit unusual since you have removed the ais...

I have installed an autodynamics tail light and the flash rate is normal even with all four blinkers changed with leds, I suppose it will be ok with the yamaha leds too... Unfortunately i have already cut the rear cables (i didn't want to remove the whole cabling) but for the front turn signals...

Yesterday i ordered the Yamaha oem led blinkers, a little pricey but i'm done with the chinese turn signals, they don't last long...

Exactly as rjafz1000 said.

Installed Satan's adapter with a R1 2008 rear shock. The difference is huge, finally i have a real suspension that works. I just have to get used to the slightly changed geometry.

No, we are asking for a recall of all FZ1s since 2006. 1. The immediate recall of all models (Fz1 2006+, Fz8, R1 2004 – 2008)... The first responce from the official distributor was negative and i think we are going to escalate to the next level (courts...) Every bike owner here knows about this...

Take a look here: Fazer Hellas Club This problem is well known here, personally i have changed the rotor twice. The first time i installed a used one so maybe thats why it happened and a second time.

I have the impression that changing gearing doesn't have much effect on top speed... This happens only if the bike hits the rev limiter with 6th gear. But most bikes hit their top speed where the engine's power is equaled by the power of aerodynamic and friction resistances. For example if a...

I have changed all four turn signals with flash-mount-led-cheap-ebay turn signals. (i have to change them again, very very poor quality and some leds have stopped working...) With the oem tail light on there was a fast blinking rate but since i installed the autodynamics led tail light...