donoharm
Well-Known Member
So I bought a ultrasonic cleaner last week
30 min later my carbs were off,stripped and took a bath
Now when reinstalling i found
-pilot jet screws had different heights at the same screw-out ( there was a good 1/2 turn diff) I eyballed them equal
-slider spring no3 is softer than the other 3, I didn't shorten the springs when I installed Ivan's jet kit.
- cyl1 exhaust is about 80C colder at idle than the others, I must recheck after sync but ....
I must make a device to check the exact spring rate, I'm sure cyl3 will run lean.
Any thoughts and advise will be appreciated.
30 min later my carbs were off,stripped and took a bath
Now when reinstalling i found
-pilot jet screws had different heights at the same screw-out ( there was a good 1/2 turn diff) I eyballed them equal
-slider spring no3 is softer than the other 3, I didn't shorten the springs when I installed Ivan's jet kit.
- cyl1 exhaust is about 80C colder at idle than the others, I must recheck after sync but ....
I must make a device to check the exact spring rate, I'm sure cyl3 will run lean.
Any thoughts and advise will be appreciated.