Chandler
Well-Known Member
Hello,
I purchased my FZ1 II with a fender eliminator kit that came with three little LEDs to light the license plate up - it flickers on and off when the bike it on. I originally thought it was just dead all together but now I have some hope thinking it was a poor splicing job.
I am getting ready to install a 6 gang fluse block as well as a relay to install a 12 V outlet, heated grips, hard wired GPS charger, etc.
Ideally I suppose I would tap into the ignition wire, but I don't want to damage it of course. I figured the safest would be the license plate light.
Does anyone have a wiring diagram or any picture to give me a jump start? As of right now I am not entirely sure where the splice is even located (I have only removed the rear sear not unbolted anything.
One more separate question - the front turn signals stay lit up and flash when I hit the blinker. My rear ones only flash when I hit the blinker. It seems normal enough to me, but I wouldn't mind more "running lights".
Are the lights supposed to remain off?
Can I change this fairly easy? - Just change out the relay, or the way the wires come into it rather?
Thanks
I purchased my FZ1 II with a fender eliminator kit that came with three little LEDs to light the license plate up - it flickers on and off when the bike it on. I originally thought it was just dead all together but now I have some hope thinking it was a poor splicing job.
I am getting ready to install a 6 gang fluse block as well as a relay to install a 12 V outlet, heated grips, hard wired GPS charger, etc.
Ideally I suppose I would tap into the ignition wire, but I don't want to damage it of course. I figured the safest would be the license plate light.
Does anyone have a wiring diagram or any picture to give me a jump start? As of right now I am not entirely sure where the splice is even located (I have only removed the rear sear not unbolted anything.
One more separate question - the front turn signals stay lit up and flash when I hit the blinker. My rear ones only flash when I hit the blinker. It seems normal enough to me, but I wouldn't mind more "running lights".
Are the lights supposed to remain off?
Can I change this fairly easy? - Just change out the relay, or the way the wires come into it rather?
Thanks