TheBustedPony
New Member
Hey yall I'm new here.
Got a Gen2 FZ1, purchased it when it was almost completely stock, but the guy provided a bunch of aftermarket parts that were obviously on the bike before. Have been putting a bunch of them on recently like sprocket, speedo healer, filter, slip on, etc. when I noticed this connector on the left side of the bike was bypassed.
Took a look in the service manual and as far as I can see, the wires are black and blue. The only two 6 pin connectors I could find with that wire are the speed sensor and air induction system solenoid (not sure if this is right tho). Anybody have a clue as to why it would be plugged up like this and/or what this connector is? It's in a big wire loom mess, so I doubt I'll be able to track it down. Appreciate any help, thanks!
Got a Gen2 FZ1, purchased it when it was almost completely stock, but the guy provided a bunch of aftermarket parts that were obviously on the bike before. Have been putting a bunch of them on recently like sprocket, speedo healer, filter, slip on, etc. when I noticed this connector on the left side of the bike was bypassed.
Took a look in the service manual and as far as I can see, the wires are black and blue. The only two 6 pin connectors I could find with that wire are the speed sensor and air induction system solenoid (not sure if this is right tho). Anybody have a clue as to why it would be plugged up like this and/or what this connector is? It's in a big wire loom mess, so I doubt I'll be able to track it down. Appreciate any help, thanks!
