DaveOG
Member
Hi Guys,
I have been doing some cleaning and o ring replacement on my carbs and needing a bit of clarification regarding the float height setting. The manual says it should be set between 12.5 and 13.5mm form the carb housing to the top of the float when held upside down. I don't know where the float should be sitting in its range of motion to be taking this reading!! Any feedback would be greatly appreciated!
I have been doing some cleaning and o ring replacement on my carbs and needing a bit of clarification regarding the float height setting. The manual says it should be set between 12.5 and 13.5mm form the carb housing to the top of the float when held upside down. I don't know where the float should be sitting in its range of motion to be taking this reading!! Any feedback would be greatly appreciated!