handlebar question

[Wh0M3]

I have noticed many of the members on the FZ6 forum talk about swapping out their bars for the FZ1 bar. I was wondering if there is a trend for what people here might swap it for but I haven't seen anything about it.

I would like to try something different on the FZ1, I would like to go low rather than high with it. I'm not sure what options there are. It seems most people here talk about going up for a more upright riding position.

Thanks

 

[85vmax]

I'm on my 2nd set of bars, and these are the best fit for me.
I wanted to go fatty and wider.....Pro Taper Fattys 1 inch up.
But my short arms made me still look like a superbike rider.

So now I run 1 up 1 back, using OEM bars from a Speed Triple made by Magura....I can ride all day and still cut corners and lay on the tank.

 

[FZ1inTX]

http://www.998cc.org/forum/gen-ii-mods/7834-convertibars-install.html and you can have the best of all worlds. High, low and whatever sweep you can muster from lock to lock steering.

 

[Wh0M3]

Thanks. That was what I was looking for.

Sent from my N860 using Tapatalk 2

 

[f5000sl]

Check out my recent post.
I installed some Renthal Streetfighter bars. Factory FZ1 clamps are too tall for the cables to reach, so I went with FZ8 lower clamps and love it.

http://www.998cc.org/forum/fz1-streetfighter/15146-fz1-1-step-closer-my-liking.html

 

[Wh0M3]

Check out my recent post.
I installed some Renthal Streetfighter bars. Factory FZ1 clamps are too tall for the cables to reach, so I went with FZ8 lower clamps and love it.

http://www.998cc.org/forum/fz1-streetfighter/15146-fz1-1-step-closer-my-liking.html

That does look nice but I ordered a set of ConvertiBars already.

Sent from my N860 using Tapatalk 2