• Welcome to the Yamaha FZ1 Forums. Member registration disables ads and allows you to post and share. Register Here.

O2 sensor plug

I have read some more some people just unplug the 02 sensor and then tape it off to prevent moisture anyone else do this with out needing a plug for it?
 
thor32766 said:
I got a great deal on a used PC3 but it didnt come with a 02 plug. Where can I get one?
Click to expand...

I just purchased a new PCIII from Ivan's. The unit did not come with the plug so I gave Ivan a call about it. He informed me that sometimes they provide the plug sometimes they don't. He also said that on his personal he does not have the plug and I should not have any issues. I don't have a error code but I have tried contacting DynoJet about it VIA there email support and have yet to receive a reply back. If they reply to me I will foward all info. I would like to have it myself even if its not required.
 
thor32766 said:
I got a great deal on a used PC3 but it didnt come with a 02 plug. Where can I get one?
Click to expand...

I received a follow up email from Chris Kelly at Dyno Jet today in regards to the O2 sensor plug. He stated that in most cases simply unplugging the sensor and taping the connector is good enough but they have seen some cases that the bike will give a error code. If you bike falls into the group that show a code you can purchase a plug from them by calling the following number 1-800-992-4993 and order O2 eliminator P/N 76423020 for a cost of $15.00 plus S/H.
 
Last edited:
You must log in or register to reply here.
Back
Top