Powercommander V Installation FZ1-07

Redline Rider

Redline Rider

Member
Visit site
Hi Guys,

I'm currently installing my new Powercommander V in preperation of the ECU Flash from Ivan.
It looks like it works well, no error codes and the bike runs fine. Note: I only idle the bike because the roads are dirty and my FZ1 doesn't like dirty roads ;).

I have just two questions left.

- The LED of the 02 Optimizer is blinking is this normal behaviour?
- How did you guys route the cable from the PCV. I route it over the left side because of the ground cable. The main cable is littlebit to long when you mount the PCV in front under the passenger seat.


Cheers!
 
Last edited:
I recieved the ECU from Ivan. i try to calibrate the tps on the pcv. The RPM and fuel adjustment is visible in the PCV software but the TPS positioning stays at 0% and gives me no voltage.

When i check the tps on the dash (with reset and select) is get 16 at idle and 91 at full throtle. Somebody any idea?
 
Last edited:
Problem solved. I contacted powercommander and they send me an older firmware version (0.1.10.6). TPS readout is now flawless.
To everyone: Don't upgrade your pcv firmware to 0.1.13!!
 
Last edited:
You must log in or register to reply here.
Back
Top