Recent content by mac69

its the 04 model ,made a new y piece for the end ,(the 2 into one piece) ,but yes fits straight up, and only cost $150 for the akrapovic pipe work and the can was brand new for $200 all from ebay........... not bad for a full titanium system

WA it sucks over this way if u want to mod ur bike ,cant even fit braided lines as its non standard ,just have to hope the cops are in a good mood ,if thy think it is non standard thy give u a yellow sticker and u have to take it to get checked over ,depending who checks it thy can make u stick...

drmgillan its not a real full graves its r1 ti akrapovic front system modded and the graves can fitted ,looks the same as the graves system for the fz1 but cost les than $400 think graves want $1400+shipping and thats for stainless pipe work will take the pegs off ,but need a seat cover...

graves

graves fitted a new graves r6 can to ti akrapovic r1 front pipes all in les than $400,and sounds good

new exhaust fitted my new home made graves system lol,r1 akrapovic conical titanium front pipe work,mated to home made y piece and graves can ,total cost $300 for a full system

not a lot oof diferance the length of mid pipes as far as i know do very little,the tuning is mostly in the down pipes (headers),a 4into 1 is a top end power pipe ,a 4 into2 into1,is a mid range power pipe ,the shorter the mid pipe the more low,mid range power,,longer gives a bit more top end ...

any one tell me the diameter of the link pipe on the yoshimura and arrow pipes ,just got a set of r1 akrapovic conical titanium pipes and need to make a new link pipe for them.......Thanks

maybe try venting ur side panels Rizoma Side Panels '06+ FZ1

lol i did think about buying the pipe as well, but the thought of polishing it up did not appeal ,have fun polishing it

have a look on ebay??

well i think it looks the part , good job,different, cost u next to f all,and no one else has one like it:Rockon: its not a bolt on part so a lot of pepole wont like it lol :D im still pondering on the 02 akras,not long moved to oz and dont know any good ti welders here ,if i was still in...

sounds like a good idea to me ,cant see why it would be any worse than the standard pipes , don't want to sound out of place but there is a lot of crowd following going on, with just bolt the aftermarket bits on ,but then its not a streetfighter forum lol

well i do have a problem ,i cant help myself , every bike i get i streetfighter ,like the bandit i built1216 kit with zx10 swing arm,r1 tail sp1 clocks etc,or my old gsxr750-1216,the 2 bikes were in the same issue of streetfighter mag' i just like to be different , and have u priced a...

well that helps him lol, but still no answer on the 02-03 exhaust fitting a gen 2 ,full titanium akrapovic system for $300 some one must know